The details of this conveyor are shown on the attached layout drawing and its basic dimensions are as follows:-
3 meter horizontal section with a 7 Meter incline section.
Infeed chain driven conveyor with double support frame and 2 ply rubber belt with heavy duty chain drive.
Belt:- 1200mm wide Ep250 / 2 ply rubber top / fabric back. With a working width of 1000mm effective width 1300mm between the sides.
Cleats:- 50mm high steel flights set at 900mm cts.
Motor drive:- Nord drive running at 13rpm fitted with a 1.5kw high efficiency motor with built in break.
Bearing 50mm bore Asahi or RHP.
Vertical side walls to conveyor for retaining material will be 800 mm high made from 3mm mild steel.
Safety stop push buttons located at the base of the conveyor. With safety pull cored system mounted above the incline section to comply with all H&S compliance for automatic balers
Material return exit chute located to the underside of the inclined section for light material to prevent material entering the underneath of the base section.
Inclined section set @ 30 degrees.
Easily removable sides for access to chain for cleaning and maintenance.
Self lubrication oiler system with rotary brush so an even spread and minimal waste of lubrication.
Feed hopper 3m long with a total height of 800mm. Approx width 1600mm.
Perfected feeding systems for our Fully Automated Balers...
Are we being too technical? don't worry, just give us a call and we will provide you with some easily understood options and a proposal with no obligations.